[7ZT7A00497] ThinkSystem Broadcom NX-E ML2 10Gb 2-Port Base-T Ethernet Adapter

Specifications

Processor / Memory
Processor 1 x BCM57416 - Broadcom

Miscellaneous
Included Accessories Low-profile bracket, full-height bracket
Compliant Standards UL, BSMI CNS 13438 Class A, RRL, CSA 22.2 No. 950, MIC, ICES-003 Class A, UL 60950-1, EN 60950-1, cTUVus, EN55024 Class A, VCCI V-3, KN24, KN22 Class A, EN55022:2010, EN55024:2010, CNS 14336, FCC CFR47 Part 15 A
Networking
Ports 10Gb Ethernet x 2
Connectivity Technology Wired
Cabling Type Ethernet 100Base-TX, Ethernet 1000Base-T, Ethernet 10GBase-T
Data Link Protocol 10 Gigabit Ethernet
Capacity Jumbo frame size: 9000
Features IPv6 support, Data Center Bridging Exchange (DCBX) support, IPv4 support, Large Send Offload (LSO), Large Receive Offload (LRO), Receive Side Scaling (RSS), Data Center Bridging (DCB), TCP Segmentation Offload (TSO), Extended Message-Signaled Interrupts (MSI-X), Generic Routing Encapsulation (GRE), Transmit Side Scaling (TSS), iSCSI boot, TCP/IP checksum offload, UDP/IP checksum offload, RDMA over Converged Ethernet (RoCE), Network Controller Sideband Interface (NC-SI), Virtual Extensible LAN (VXLAN), Network Virtualization using Generic Routing Encapsulation (NVGRE), Jumbo Frames support (up to 9000 bytes)
Compliant Standards IEEE 802.3ab, IEEE 802.3an, IEEE 802.1Qbb, IEEE 802.1Qaz

General
Device Type Network adapter
Form Factor Plug-in card
Interface (Bus) Type Mezzanine LAN-on-Motherboard Generation 2 (ML2)
Expansion / Connectivity
Interfaces 2 x network - RJ-45